STEPPERONLINE 2.4Nm 340oz.in Nema 23 Stepper CNC Kit Motor & 1~4.5A Driver

About this item

This CNC kit pairs a Nema 23 stepper motor with a DM542T digital driver, ready to wire into your motion control setup. The motor puts out 2.4Nm of holding torque with a 4-wire, 8mm shaft design, while the driver handles 18-50VDC input and up to 4.5A peak output with adjustable microstepping. Built-in protections and auto motor detection make setup straightforward for CNC routers, 3D printers, and similar projects.

• Kit includes one Nema 23 stepper motor (23HS32-4004S) and one DM542T digital driver
• Motor delivers 2.4Nm (339.87 oz.in) holding torque, 1.8° step angle, 4.0A per phase, 57x57x82mm body, 8mm shaft
• Driver runs on 18-50VDC input, outputs 1.0-4.5A peak current, works with Nema 17, 23 and 24 motors
• 16 selectable microstep resolutions (200 to 25600) and 8 selectable current settings for fine motion control
• Optically isolated input, automatic idle-current reduction, over-voltage/over-current protection, soft start

Specifications

EAN

0742803053950

MPN

1-DM542T-23HS32

UPC

742803053950

Brand

StepperOnline

Inductance

3.2mH±20%(1KHz)

Pulse Width

2.5μS

Current Type

DC

Holding Torque

2.4Nm(339.87oz.in)

Shaft Diameter

8mm

Full Step Angle

1.8° (200 Steps)

Number of Leads

4

Insulation Class

B 130°C[266°F]

Country of Origin

China

D-cut Shaft Length

15mm

Isolation Resistance

500MΩ

Resistance per Phase

0.9ohms

Wiring Configuration

4-Wire Bipolar

Rated Current per Phase

4.0A

Actual Rated Input Voltage

24-48VDC

Nominal Rated Input Voltage

24 V, 48 V, 24-48VDC